Response SL5 Instrukcja Obsługi Pobierz pdf (Strona 7)

LATCH KEY

When the system is Disarmed the Latch Key facility,

if enabled, will call the first Latch Key phone number

and replay the user message (recorded under latch

key setup) for the set ‘Play Time’. The recipient must

acknowledge the message by pressing the button on

their telephone keypad. If the call is unanswered or

an acknowledgment is not received then the second

Latch Key phone number will be called. The Voice

Dialler will continue calling each number in turn until

each number has been dialled the set number of

times or the sequence is cancelled/acknowledged by

the recipient.

For example, the Latch Key facility is useful to inform

parents that a child has returned from school and

Disarmed the system.

REMOTE PHONE ACCESS

AND CONTROL

It is possible to dial into the system via the connected

telephone line to interrogate the system status and to

have basic control over the system, (e.g. to Arm and

Disarm the system). You may also activate the

microphone on the Control Panel to Listen-In to what

is happening in the protected property.

TAMPER PROTECTION

All system devices (except any Remote Control

Units) incorporate Tamper protection features to

protect against unauthorised attempts to interfere

with the device.

Any attempt to remove the battery cover from any

device (except a Remote Control) or to remove the

Solar Siren or Control Panel from the wall will trigger

the alarm even if the system is Disarmed (unless the

system is in Test or Program modes).

JAMMING DETECTION

In order to detect any attempts to illegally jam the

radio channel used by your alarm system, a special

jamming detection function is incorporated into the

Control Panel. If this feature is enabled, an alarm

will be triggered if the radio channel is jammed

continuously for more than 30 seconds or if the

system is jammed for more than 3 periods of

10 seconds in a 5 minute period. At full alarm it will

beep for 3 seconds and will alarm after 10 seconds,

at Part Arm it will beep for 3 seconds.

The jamming detection circuit will constantly scan for

jamming signals. However, it will also detect and

could in extreme cases be triggered by radio signals

from other radio equipment within range operating on

the same frequency which would not interfere with

the normal operation of your alarm.

When activating jamming detection the system

should be monitored carefully for false jamming

alarms for at least 2 weeks before leaving the

Jamming Detection function permanently enabled.

BATTERY MONITORING

All devices powered by non-rechargeable batteries

incorporate a battery level monitoring feature which

will warn of a low battery status.

In addition the Control Panel will also indicate a low

battery status on any PIR (Passive Infra-Red) or

Magnetic Door/Window Detector on the system.

The batteries on any device indicating a low battery

status should be replaced immediately.

If you are planning to operate the Jamming

Detection feature we recommend that you wait

at least 30 days before activating this feature to

allow time for you to become familiar with the

operation of your system.

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Komentarze do niniejszej Instrukcji

Brak uwag

Response SL5 Instrukcja Obsługi Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Response SL5