Response SL5 Instrukcja Obsługi Pobierz pdf (Strona 42)

PART-ARM 2

This controls whether the zone is active when

Part-Arm 2 is armed.

Default setting: OFF (all zones)

Scroll through the Zone menu until ‘3.6 Zxx Part-Arm 2’

(and the current setting) is displayed.

To change the setting press .

Press to enable the zone in part arm 2, or

Press to disable the zone in part arm 2.

CHIME

This controls whether the zone will operate with

Chime Mode.

Default setting: OFF

Available for all zones 1- 36 only if detector is a

PIR/MAG. Only available for wireless zones 1-32 if

a detector is linked. Smoke detectors automatically

disabled in Chime Mode.

Scroll through the Zone menu until ‘3.7 Zxx Chime’

(and the current setting) is displayed.

To change the setting press .

Press to enable the zone in chime mode, or

Press to disable the zone in chime mode..

MONITORING SETUP

REMOTE MANAGER

The parameters in this menu configure the system

telephone dialler to interface to the Alarm

Monitoring Service following the occurrence of an

appropriate alarm or system event.

Scroll through the menu until ‘6. REMOTE

MANAGER SETUP’ is displayed and press .

Note: After completing the Remote Manager Setup

press to return to the top level programming

menu.

PHONE NUMBER 1

Scroll through the menu until ‘6.1 Phone No.1:’ is

displayed and press .

Enter phone number 1 (see the Monitoring

welcome leaflet enclosed).

Press to save new setting and exit, or

Press to exit without saving.

PHONE NUMBER 2

To setup Remote Manager phone number 2 select

‘6.2 Phone No.2:’ from the menu and follow the

procedure above.

UNIT ID CODE

Scroll through the menu until ‘6.3 Unit ID:’ is displayed

and press .

Enter the 4 digit System ID Code obtained from

the Alarm Monitoring Service provider (see the

Monitoring welcome leaflet enclosed).

This is not to be confused with the System

Access Code or any User Access Codes.

ENTER

ESC

ENTER

Note: For the telephone dialler to operate

correctly with the Alarm Monitoring Service the

‘Dialler Mode’ (see System Setup) must be

correctly set and programmed.

PROGRAM MODE

Code:

enter Master User Access Code and press ENTER

6. REMOTE

MANAGER

press ENTER

Enter Phone No: Enter Unit ID:Enter Phone No:

(32 digits max) (32 digits max) (4 digits max)

6.1 Phone No.1

xxxxxxxxxxxxxx

6.3 Unit ID:

xxxx

6.2 Phone No.2

xxxxxxxxxxxxxx

press ENTER press ENTER press ENTER

ENTER

Notes:

Press to insert a 3.5 seconds pause in

the dialling sequence.

Press to move the cursor left.

Press to move the cursor right.

Press to delete the number under

the cursor.

Press (and hold) to erase the entire

number.

ENTER

ESC

ENTER

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 63 64

Komentarze do niniejszej Instrukcji

Brak uwag

Response SL5 Instrukcja Obsługi Strona 42

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Response SL5