Response SL8 Instrukcja Obsługi Pobierz pdf (Strona 13)

4. Where possible, mount the Detector in the

corner of the room so that the logical path of an

intruder would cut across the fan detection

pattern. PIR Detectors respond more effectively

to movement across the device than to

movement directly towards it.

5. Do not position the Detector in a position where

it is subject to excessive vibration.

6. Ensure that the position selected for the PIR

Detector is within effective range of the Siren.

7. Do not fix the PIR Detector onto or very close

to metalwork (i.e. radiators, water pipes, etc) as

this could affect the radio range of the device.

Note: When the system is Armed, pets should not

be allowed into an area protected by a PIR Detector

as their movement could be detected and trigger

an alarm.

INSTALLING AND CONFIGURING THE

PIR DETECTORS

1. Undo and remove the fixing screw from the

bottom edge of the PIR Detector, (keep the

screw safe for later). Carefully pull the bottom

edge of the detector away from the rear cover

and then slide down to release the top clips.

2. Carefully drill out the required mounting holes in

the rear cover using a 3mm drill according to

whether the unit is being mounted in a corner or

against a flat wall.

3. Using the rear cover as a template, mark the

positions of the fixing holes on the wall.

4. Fix the rear cover to the wall using the two

18mm No.4 screws and 22mm wall plugs,

(a 5mm hole will be required for the wall plugs).

Do not over-tighten the screws as this may

distort or damage the cover.

Note: The wall plugs supplied with the product

are not suitable for plasterboard walls, if

mounting the Detector onto plasterboard use

appropriate wall plugs.

5. To select the required sensitivity, set switch SW3

as follows:

UP HIGH sensitivity

DOWN LOW sensitivity

Note: The recommended setting is LOW for a

most normal environments, if set to HIGH and

false alarms are experienced change the setting

back to LOW.

Rear Cover

Fixing

Screw

Rear Cover

Flat Wall

Mounting

Corner Wall

Mounting

Fixing

Screw

SW2

(Tamper)

SW1

(Test Mode)

SW3

(Sensitivity)

SW3 up

High Sensitivity

SW3

Sensitivity

Low

SW3 down

Low Sensitivity

SW3

Sensitivity

Low

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Response SL8 Instrukcja Obsługi Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Response SL8