Response SA1 E Instrukcje Operacyjne Pobierz pdf (Strona 20)

MAINTENANCE

Your alarm system requires very little maintenance.

However, a few simple tasks will ensure its continued

reliability and operation.

IMPORTANT: If, for any reason you have to

completely power-down the system (e.g. to move

the system to new premises), rst put the system

into Service Mode before removing the Siren cover

and disconnecting the main rechargeable and initial

power-up batteries. Ensure that the solar panel

is covered with a lightproof material to prevent it

being energised, otherwise the solar panel may still

power the siren.

SOLAR SIREN

1. It is recommended that the Solar Panel on the top

of the siren housing should be cleaned at least twice

a year, preferably in the Spring and Autumn, using a

soft damp cloth. Do not use abrasive, solvent based

or aerosol cleaners. Do not attempt to clean inside the

unit or allow water to enter the unit.

This will ensure that the Solar Panel does not become

affected by the build up of excessive dirt and receives

all the available light.

2. The Siren should not be left for long periods with

the batteries connected, unless the unit is able to

receive sufcient light to maintain the battery charge.

Failure to maintain charge to the unit will result in the

rechargeable battery running unacceptably low. Should

this occur, the unit must be recharged from a 7.5Vdc/

100mA supply (e.g. from a mains adaptor power

supply). When re-powering the Siren t a new 9V PP3

leak proof Alkaline power-up battery to ensure that the

Siren receives sufcient power until the solar panel can

recharge the main battery.

3. The main rechargeable battery has a typical life of 3

- 4 years and needs no maintenance during this period,

provided the battery is kept charged. The battery will

be damaged if it is stored in a discharged state for long

periods.

IMPORTANT: Before removing the Siren from

the wall ensure that the Siren is rst switched

into Service Mode to prevent the Tamper switch

operating and triggering an alarm, (see page 19).

The Siren must be switched back into Operating

Mode, otherwise the system cannot be Armed.

DETECTORS, REMOTE CONTROL AND

KEYPAD

The detectors require very little maintenance. The

batteries should be replaced once a year or when a low

battery status is indicated.

BATTERIES

Note: Before removing the battery cover on any device

to replace the battery ensure that the Siren is switched

into Service Mode to avoid triggering an alarm.

The specications for replacement batteries are as

follows:

Remote Control:

1 x 3V CR2032 Lithium Cell (or equivalent)

Magnetic Contact Detector:

2 x 3V CR2032 Lithium Cells (or equivalent)

PIR Movement Detector:

1 x 9V PP3 Alkaline Battery

Keypad:

1 x 9V PP3 Alkaline Battery

Note: Rechargeable batteries should NOT be tted.

DISPOSAL

At the end of their useful life the packaging, product

and batteries should be disposed of via a suitable

Recycling Centre.

Do not dispose of with your normal household waste.

DO NOT BURN.

The Rechargeable Batteries contain Sulphuric Acid

– DO NOT ATTEMPT TO OPEN THE CASING.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Response SA1 E Instrukcje Operacyjne Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Response SA1 E