Response SA1 E Instrukcje Operacyjne Pobierz pdf (Strona 15)

INSTALLING AND CONFIGURING

THE SIREN

1. Remove the xing screw from the bottom edge of the

Siren housing and carefully hinge off the front cover.

Hold the mounting plate in position and mark the

positions of the 4 mounting holes. A spirit level placed

on the casing will help ensure you get the unit perfectly

level.

2. Drill four 6mm holes and t the 26mm wall plugs.

3. Fit the two 30mm xing screws in the top holes

leaving approximately 10mm of the screw protruding.

4. Fit the top keyhole slots of the mounting plate over

the screw heads. Remove the mounting plate and

adjust the screws until they form a neat t with the

mounting plate with minimal movement.

5. Secure the mounting plate in position using the two

25mm xing screws in the bottom xing holes.

6. Ensure that the Siren’s main conguration switch on

the LED Indicator board is set to “C.U.” for use with this

alarm system.

7. Undo the three screws holding the DIP Switch Cover

in place and remove the cover (see main diagram

opposite).

8. Under the cover you will nd a series of 9 DIP

switches.

Note: When the Siren is viewed as shown above (Solar

panel at top) the DIP switches are ‘upside down’.

9. DIP switches 1-8 are used to set the House Code

for the Siren and must be set to the same ON/OFF

combination as all other system devices.

10. If required, the maximum length of time that the

Siren will sound for when activated under an alarm

condition may be extended to 3 minutes using DIP

switch 9 as follows:

ON = 3 minutes

OFF = 1 minute

11. The Siren will acknowledge Arm and Disarm signals

from the Remote Control and Keypad by beeping. It

is possible to disable these acknowledgement beeps if

required by removing the jumper link P2 on the circuit

board.

P2 tted = Beep enabled

P2 removed = Beep disabled

12. If for any reason you need to disable the Siren,

remove jumper link P3 on the Circuit board. This

will prevent the Siren from sounding during an

alarm condition. However, the Siren will still beep to

acknowledge signals from the Remote Control and

Keypad, (provided the beep feature is not disabled).

IMPORTANT: The Jumper Link (P3) is small so will

need to be stored in a safe place until you need to

reinstate the Siren alarm.

P3 tted = Siren enabled

P3 removed = Siren disabled

13. To enable the Jamming Detect feature in the Siren

t the jumper link taped to the cover of the Siren control

unit across link pins P1 on the circuit board.

P1 tted = Jamming Detection enabled

P1 removed = Jamming Detection disabled

14. Ret the DIP switch cover and replace the 3 cover

xing screws. Do not over tighten the screws as this

could damage the thread.

POWERING UP THE SIREN

1. Connect the 9V PP3 power-up battery to the

battery clip.

Connect the rechargeable battery to the charging

leads. Connect the Red lead to the Red ( + ) terminal

and the Black lead to the Black ( - ) terminal. Both

indicator LEDs will ash together in a single long ash

to indicate that the unit is operational.





































 



1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Response SA1 E Instrukcje Operacyjne Strona 15

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Response SA1 E