Response RE3000S Instrukcje Operacyjne Pobierz pdf (Strona 11)

The Control Unit will acknowledge the signal by

bleeping twice and memorise the ‘House Code’ set

in the Remote Control. The Zone LED’s 1-6 will now

indicate the ‘House Code’ switch setting selected for

each switch 1-6 in the Remote Control as follows:-

‘+’ = LED ‘ON’

‘o’ = LED ‘FLASHING’

‘-’ = LED ‘OFF’

5. Once the ‘House Code’ has been set, press

twice to exit programming mode.

Note: It is possible to manually programme the‘House

Code’ into the Control Unit, if a Remote Control is not

available or not required - Refer to Programmable

Functions - page 15.

SETTING THE CONTROL

UNIT TO TEST MODE

Before installing Magnetic Contact Detectors, Passive

Infra Red Detectors or other accessories you should

set the Control Unit to Test mode. This will help to

ensure that the correct ‘House Code’ is used and to

establish the radio range.

1. Press and hold the button, until the Control

Unit emits 2 bleeps and the Full Arm and Part

Arm LED’s flash.

2. The system is now in Test mode.

3. Now, each time the Control Unit receives a

valid radio signal from a Detector or Remote

Control, the Control Unit will emit 2 two-tone

chimes and the associated Zone LED will flash

for approximately 3 seconds.

To test the radio range of the Control Unit’s receiver,

press and release the Disarm (Blue) button on the

Remote Control from in and around the property and

from all locations where you plan to install the Detectors

and check that the Control Unit acknowledges the

signals by emitting the two-tone chime (and flashing the

Medical Alert (Zone 8) LED for 3 seconds).

The Control Unit should be left in Test mode whilst the

detectors and other accessories are set up and installed.

However, if you wish to exit the Test mode, press and

hold the button until the unit emits 2 bleeps and

the Arm/Part Arm LED’s extinguish.

SYSTEM ZONING

The RE5000 Detectors can be set to operate on any

one of 6 Zones. There is no limit to the number of

Detectors that can be installed on a Zone, although

we recommend that only one Detector is installed per

Zone for ease of alarm verification. Alternatively

where more than 6 Detectors are installed, group all

the Detectors in one area/room on the same Zone.

Zone selection is set on each Detector using the 3

position miniature switches 7 and 8, as follows:-

In addition to a Radio Detection Alarm input on Zone

6, facilities are available on the Control Unit Terminal

block to also hard-wire a normally closed (open on

alarm) circuit on Zone 6. The hard-wired Zone should

be wired across terminals ‘Zone 6’ and ‘GRD’ on the

Control Unit terminal block.

Zone 6 also monitors the Control Unit Tamper Circuits,

ie Control Unit fixing/battery cover Tamper switch and

(where fitted) hard-wired siren tamper return.

Separate Zone inputs are available for Fire Alarm

(Zone 7) and Medical Alert (Zone 8).

These Zones are pre-programmed into the RE5000SD

Smoke Detectors and RE5000MP Medical Alert

Pendant respectively. These devices cannot be

assigned to different Zones.

RE5000S Professional Alarm System 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Komentarze do niniejszej Instrukcji

Brak uwag

Response RE3000S Instrukcje Operacyjne Strona 11

Komentarze do niniejszej Instrukcji